Ancillary equipment > Hopper dryers

Every plastic factory, whether it is engaged in Injection moulding, blow moulding or extrusion, would invariably require various ancillary equipments.

INTRODUCTION TO HOPPER LOADERS

Hopper dryers are used for pre heating and drying the plastic resins in pellets / granules form with wide range of temperature settings. They are designed for plastic industry with feed back improvements. Most reliable dryers in India cuts energy cost and increase productivity.

Plastic hopper dryers provide quick and uniform pre heating and drying of plastic resins. Due to drying through hot air, in modern industry they are becoming unique choice over drying ovens conventially being used for drying and preheating. Plastic hopper dryers not only provide better performance but also consume lesser energy as compared to ovens.

Plastic hopper dryers are designed for easy handling, so any colour material could be changed in very short time. Pay back of equipments cost with 6 months. Dryer design and manufacture by stainless steel to prove advantages of on line drying and cut your power cost up to 70%.

WORKING PRINCIPLE

Plastic hopper dryer consists a steel hoper a blower and heater with automatic temperature indicator controller. After drying hopper is fed fully with the plastic resins to be dried, the dryer is switched on.

The blower sucks in the ambient air blows over the heaters, which raises the air temp. This hot air passing through plastic resins picks up the moisture. The air after absorbing the moisture is led off from the dryer to atmosphere. The automatic temperature controller ensures uniform drying temperature also helps in energy conservation. The drying through hopper dryer ensures improved quality and good surface finish of molded components with enhanced injection rate.

FEATURES: Filter provided at the blower suction to ensure no entry of dust. Ensures faster injection cycle. Cyclone separator at the outlet to ensure that plastic dust not escape to working atmosphere. Hoppers are insulated thus energy saving. The material will be in touch only with stainless steel or cast aluminum. Automatic temperature controller with digital display. Unique air distributor for better air distribution thus uniform drying and pre heating. Unique hinge / clips arrangement for cleaning the hopper.

We have the following models available: